Konsberg AIS 200, Руководство по установке

Страница: 39 / 119

Kongsberg AIS 200 Installation Manual, rev. 2 Connecting & configuring external equipment
4. CONNECTING AND CONFIGURING
EXTERNAL EQUIPMENT
4.1 General
In general, all sensors installed in compliance with other carriage requirements of SOLAS
Chapter V should be connected to the AIS 200 system.
Increased navigational performance can be achieved by interfacing the AIS 200 to an ECDIS,
ECS and/or radar.
All external equipment is connected to the AIS 200. For termination, refer
Data signals page
25.
VHF-transmitter
VHF-receive ch. 70
VHF-receive ch. AIS 1
VHF-receive ch. AIS 2
GPS receiver
Int
erface bo
ard
VH
F
sw
it
ch
AIS Transponder
GNSS/DGNSS
Antenna
VHF Antenna
Heading
GNSS
Rate of Turn
ECDIS
Radar
MKD unit
Note!
Shielded twisted pair cables shall be used for the high-speed serial data ports.
The following sections present the port configuration and IEC 61162-1 sentences that may be
used when connecting external equipment to the AIS 200 system. Detailed description of the
IEC 61162-1 sentences are found in
Appendix B - Digital interface IEC 61162-1 , page 59.
For terminal location, refer to the figure on page 25.
4.2 Presentation interface
The presentation interface consists of two physical ports: PI and Pilot port. Both ports are
functionally equivalent.
The
PI port provides a primary port for connecting onboard equipment such as ECDIS, radar,
Long Range AIS etc.
The
Pilot port is used for the Pilot Plug included in the AIS 200 system. This plug is intended
for the ship's pilot equipment, service equipment, etc.
29