Konsberg AIS 200, Руководство по установке

Страница: 103 / 119

Kongsberg AIS 200 Installation Manual, rev. 2 Appendix C - Software setup using optional MKD
= = = S e c u r i t y = = = = = = = = P 1 c
A u t
3. Enter AIS (default security code), and
h o r i s a t i o n
- - - - - - - - - - - - - - - - - - - - - - - - -
L 1 P I N C o d e : * * * * * * * *
L 2 P I N C o d e : * * * * * * * *
the
ENTER
button.
N a v . S t a t u s : 0
V o y a g e D a t a : 0
D a t a : 1
4. Now enter the new security code for
Level 1, an
S t a t i c
= = = = = = = = = = = = = = = = = = = = = = = = =
E n t e r a u t h o r i s a t i o n c o d e
P I N :
= = = = = = = = = = = = = = = = = =
D E F G H I J K L M N O
S T U V W X Y Z 1 2 3 4
and pressing the
ENTER
button.
ht the L2 PIN Code and repeat the procedure abov
= = = = = = =
A B C
P Q R
confirme the entry by moving the
highlight to the symbol and pressing
d confirmed the entry by
moving the highlight to the symbol
. Highlig e to change the security code
for Level 2.
w codes are lost, a
master code can be obtained from Customer Support by supplying the MAC address, see
o avoid unauthorised input of data in the menus accessed from the Main menu, the AIS 200
sy des a
N
on the Security page are p e has
to be entered before any parameters can be changed. Refer item 3 below.
ctivate the Security menu from the Main menu.
5
6.
Record the new codes and keep them in a safe location. If the ne
pages 95 and 96.
11.1.2 Changing the security levels
T
stem should be set up with security co nd different access levels.
rotected by L2 security code. This cod
ote!
All entries
A
= = = S e c u r i t y = = = = = = = = P 1 c
A u t h o r i s a t i o n
- - - - - - - - - - - - - - - - - - - - - - - - -
L 1 P I N C o d e : * * * * * * * *
L 2 P I N C o d e : * * * * * * * *
N a v . S t a t u s : 0
V o y a g e D a t a : 0
S t a t i c D a t a : 1
C h n . M g m t : 2
V H F L i n k : 1
S e r i a l P o r t s : 1
N e t w . S e t t i n g s : 2
A n s w e r M o d e : 1
Highlight the parameter group for which the
security level is to be changed, and press the
ENTER
button. The lower part of the display
will now show the keyboard function.
Enter the security code for Level 2, move the
highlight to the symbol and press the
ENTER
button. In the lower part of the display it will
now be possible to change security level for the
selected parameter.
= = = = = = = = = = = = = = = = = = = = = = = = =
0 1 2
93