CMP-ROUTER12
4 Port Router
Quick Installation Guide
1.1 System Requirements
Broadband Internet Access Service (DSL/Cable/Ethernet)
One DSL/Cable modem that has an RJ45 connector (It’s not necessary if you connect the
router to Ethernet)
Each PC on the LAN needs a working Ethernet Adapter and an Ethernet cable with RJ45
connectors
TCP/IP protocol must be installed on each PC
Web browser, such as Microsoft Internet Explorer 5.0 or later, Netscape Navigator 6.0 or
later
1.2 Connecting the Router
Before you install the router, you should connect your PC to the Internet through your broadband
service successfully. If there is any problem, please contact with your ISP for help. After that,
please install the router according to the following steps. Don't forget to pull out the power plug.
1.
Power off your PC(s), Cable/DSL modem, and the router.
2.
Connect the PC(s) and all Switches/Hubs on your LAN to the LAN Ports on the router,
shown in figure 1-1.
3.
Connect the DSL/Cable modem to the WAN port on the router, shown in figure 1-1.
4.
Connect the AC power adapter to the AC power socket on the router, and the other end
into an electrical outlet. The router will start to work automatically.
5.
Power on your PC(s) and Cable/DSL modem.
Switch/Hub
To WAN
To LAN
£¨£©
XDSL
Cable
Ethernet
¡¢¡¢
RESET
Figure 1-1 Hardware Installation of the CMP-ROUTER12 Cable/DSL Router
After connecting the CMP-ROUTER12 router into your network, you should configure it. This
chapter describes how to configure the basic functions of your CMP-ROUTER12. These
procedures only take you a few minutes. You can access the Internet via the router immediately
after it has been successfully configured.
1.3 TCP/IP configuration
The default IP address of the CMP-ROUTER12 is 192.168.1.1, and the default Subnet Mask is
255.255.255.0. These values can be seen from the LAN, and can be changed as your desire. As
an example, we use the default values for description in this guide.
Connect the local PCs to the LAN ports on the router. There are then two means to configure the
IP address for your PCs.
Configure the IP address manually
1)
Set up the TCP/IP Protocol for your PC(s). If you need instructions as to how to do
this, please refer to the detailed manual on the CD.
2)
Configure the network parameters. The IP address is 192.168.1.xxx ("xxx" is from 2
to 254), Subnet Mask is 255.255.255.0, and Gateway is 192.168.1.1 (The router's
default IP address)
Obtain an IP address automatically
1)
Set up the TCP/IP Protocol in "Obtain an IP address automatically" mode on your
PC(s). If you need instructions as to how to do this, please refer to the detailed
manual on the CD.
2)
Power off the router and PC(s). Then turn on the router, and restart the PC(s). The
built-in DHCP server will assign IP addresses for the PC(s).
1.4 Quick Installation Guide
With a Web-based (Internet Explorer or Netscape
®
Navigator) utility, the CMP-ROUTER12 is
easy to configure and manage. The Web-based utility can be used on any Windows, Macintosh
or UNIX OS with a web browser.
Connect to the router by typing
http://192.168.1.1
in the address field of web browser.
Figure 1-2 Login to the router
After a moment, a login window will appear similar to that shown in Figure 1-3. Enter “
admin
” for
the User Name and Password, both in lower case letters. Then click the OK button or press the
Enter key.
ENGLISH
INSTRUCTIONS
EN
