Assembly
To assemble the speaker tilt connector, proceed as follows:
1.) Unpack and check item for damage and completeness
● Holder
● Mounting bolt
● Clamping screw
● Cylinder head screw M10 x 95 mm, washer,
●
nut M10 and protective cap
2.) Assembly of mounting bolt and clamping screw
Guide the cylinder head screw through the
mounting bolt.
Screw on the washer and nut from below.
Using a suitable tool, tighten the screw connec-
tion and put the protective cap on the nut. By
adjusting the mounting bolt via the slotted hole,
the center of gravity of the loudspeaker can be
varied.
The clamping screw should be screwed
into the thread.
