Konica Minolta Drypro 832, Руководство пользователя

Страница: 43 / 84

1
2
3
4
5
6
7
8
9
1 0
1 1
1 2
43
3�4 Calibration
This function is used to correct the film density property.
This machine provides automatic density control of an image when a new film is loaded via a
densitometer incorporated in the cooling / transport unit. You do not normally need to correct the
image density. However, if any abnormal density should occur, including the “NG” result of output of
the QC pattern in test print, print the calibration sheet, following the steps below. Density correction is
automatically performed.
The calibration sheet is used to collect data for automatic density correction (i.e. data whose density is
not corrected). If you check or manage the density, use the the QC pattern output in test print.
"3.5 Test Print" (page 45)
"5.2 Operation of Test Print" (page 65)
1
When “Ready” appears in the message display window, press the
[Calibration] button on the operation panel�
The following messages appear in the message display window.
If optional Lispl-832 is installed:
Pressing the [Reset/Cancel] button switches to Tray 2. Pressing the
[Reset/Cancel] button once again returns you to the state (“Ready” appears in the
message display window) before pressing the
[Calibration] button.
To perform calibration because the result of output of QC pattern
was “NG”, select the tray in which the abnormal density occurred�
2
Press the [Open/Enter] button�
The following message appears in the message display window.