Konica Minolta CM-M6, Инструкция по эксплуатации

Страница: 85 / 128

82
3
En
vir
onment Set
tings/Other Set
tings
„
Warning Level Setting
Memo
The warning level is set to “80%” under the initial settings.
Operating Procedure Start the procedure from the <Setting> - <Default data setup> screen.
1
Use [

] or [

] to move the cursor to “Warning
level”, and then press the [Confirmation] key.
The <Warning level> screen
is displayed.
2
Use [  ] or [  ] to change the value.
Settings
„ {
000 to 100%
3
Press the [Confirmation] key after completing the
changes.
The setting is confirmed and the screen returns to the
<Default data setup> screen .
Notes
If [ESC] is pressed during configuration, the settings will
not be changed and the screen will return to the
<Default data setup> screen.
„
Parametric Coefficient Setting
Memo
• The parametric coef. is set to “1.00” under the initial settings.
• Parametric coefficients can be edited only when the difference equation is “CMC”, “ΔE*94”, or “ΔE00”.
Operating Procedure Start the procedure from the <Setting> - <Default data setup> screen.
1
Use [

] or [

] to move the cursor to “Parametric
coef.”, and then press the [Confirmation] key.
The <Parametric coef.> screen
is displayed.
Sample
Setting
0002 TARGET-2
Default data setup
Default tolerance
Parametric coef.
Warning level
80%
Sample
Setting
0002 TARGET-2
Default data setup
Default tolerance
Parametric coef.
Warning level
80%
0 8 0
%
Fail
Pass
Warning level
Sample
0002 TARGET-2
Default data setup
Default tolerance
Parametric coef.
80%
Warning level
Setting