Konica Minolta bizhub C203 Series, Руководство пользователя

Страница: 135 / 534

C353/C253/C203 2-66
Basic copy operations
2
– When the "Corner" Staple setting is selected.
– Touch [Auto] to automatically determine the stapling position according to the orientation of the
loaded original. If the original length is 297 mm or less, the long side of the paper is stapled. If the
original length is more than 297 mm, the short side of the paper is stapled.
– If "Auto" is selected for the stapling position, load the original with the top toward the back of the
machine. If the original is loaded in any other orientation, the stapling will not be correctly
positioned.
– If "Auto" is selected, the stapling position is set at the top or at the left.
– To cancel the setting and select the default, press the [Reset] key.
4
If desired, touch [Original Direction], and then select the setting appropriate for the original.
– For details on specifying the original orientation, refer to "Selecting the original orientation
(Original Direction settings)" on page 2-20
.
5
Touch [OK].
The Basic screen appears again.
2.12.5 Punching holes in copies (Punch settings)
!
Detail
In order for holes to be punched in the copies, all of the following conditions must be met.
The paper width must be between 182 mm and 297 mm.
The paper length must be between 182 mm and 432 mm.
If a Punch setting is to be selected, select the orientation in which the original is positioned. If an Original
Direction setting is not selected, holes may not be punched in the copies as desired.
For details on specifying the original orientation, refer to
"Selecting the original orientation (Original
Direction settings)" on page 2-20
.
2
Note
The Punch settings are available only if the punch kit is installed on the optional finisher.
Type of punch kit Paper weight Paper size
Punch kit PK-515 60 g/m
2
to 256 g/m
2
A3 w , A4 v , B5 w
Punch kit PK-501 60 g/m
2
to 209 g/m
2
A3 w , A4 v