Konica Minolta bizhub 360, Руководство пользователя

Страница: 605 / 692

Utility <Administrator Setting> 15
bizhub 360 15-59
U
tility <Administr
ator Setting>
Chap
te
r 1
5
5
Select the condition to operate the ADF Frame Erase function.
Select whether or not to operate this function whenever using ADF, and
also specify the erase amount.
– Touch [ADF Frame Erase] to highlight it, then specify the desired
erase amount using [+] and [–] under Job Setting in the right side
area of the screen.
Available range is 1 to 5 mm. Over 5 mm of the erase amount can-
not be specified.
– To disable this function, specify 0 mm as erasure amount.
– This setting will be valid just after specified.
6
If further changes are required, touch the desired key.
15.2.17 7 Expert Adjustment>3 Finisher Adjustment
Use this function to make the following adjustments for finisher options.
Adjustment menu items may differ depending upon the configuration of the
machine options being installed.
To specify Finisher Adjustment
0
Perform Center Staple Position and Half-Fold Position for the machine
with Finisher FS-510 and Saddle stitcher SD-502 installed.
0
Perform Punch Horizontal Position and Punch Resist Loop Size for the
machine with Finisher FS-510 and Punch unit PU-501 installed, or for the
machine with Finisher FS-511 installed.
0
Follow the steps as 1-2-3-7-8 for making Center Staple Position.
Follow the steps as 1-2-4-7-8 for making Half-Fold Position.
Follow the steps as 1-2-5-7-8 for making Punch Horizontal Position.
Follow the steps as 1-2-6-7-8 for making Punch Resist Loop Size.
1
Follow the procedure on page 15-2 to display the Administrator Setting
Screen.