Konica Minolta Bizhub 222, Руководство по обслуживанию

Страница: 834 / 846

Field Service Ver. 1.0 Dec. 2008 8. Mechanical adjustment
33
SD-507
ADJUSTMENT/
SETTING
8. Mechanical adjustment
8.1 Fold Angle Adjustment
NOTE
Make this adjustment after any of the following procedures has been performed.
• When the Folding Unit has been replaced.
• When a slant occurs in the crease.
1. Enter the Crease mode and make a copy. (A3 or 11x17 Size)
2. Fold the output paper along the
crease [1].
3. Fold the output paper and half and
measure the width A of the paper.
Specification: 0 ± 1.5 mm
4. If the fold position is slanted as
shown on the left, make the following
adjustment.
5. Open the Front Door, loosen the
adjustment screw [2], and move the
Folding Unit to the left to make the
adjustment.
Graduated in 1-mm divisions
• If the fold position is slanted opposite
to the figure of step 4, move the Fold-
ing Unit to the right to make the adjust-
ment.
6. Make another copy and check the fold position.
4511F3C501DA
[1]
A
Exit direction
Center
4511F3C502DA
[2]