Konica Minolta 0902, Руководство по обслуживанию

Страница: 276 / 302

Chapter 7 Periodic Maintenance
7-6
7.2.3 Secure the Maintenance Space
If the maintenance procedure is difficult to perform at the installation site, move the equipment to a place
capable of performing the maintenance.
1
Move the optical unit to the second front side and
fix it using the simple fixing lock.
2
Loosen the adjuster (4 locations).
3
Move the equipment to a place capable of
operation.
Secure a space of 600 mm around each side of the
equipment.
4
Fix the equipment so it will not move using the
adjuster (4 location) after moving it.
5
Release the simple fixing lock.
Lock will be released by pulling up the blue knob.
This completes the securing of the maintenance space.
Go to
"7.2.4 Removal of Exterior Panels and Insertion Unit (Page 7-7)" to remove the exterior panels and
the insertion unit.
Note
•
When the optical unit moves all the way
toward the front, fixing shaft will
automatically lower to lock.
•
The second front door that is locked with
the simple fixing lock cannot be fully
closed. (for the purpose of preventing
the unit from being left locked).
Over 600 mm Over 600 mm
Over 600 mm
Over 600 mm
Important
Push the optical unit slightly towards the
back when pulling up the knob. Fixing shaft
might move down, and get locked again if
the optical unit is at its hithermost position.
Also, move the optical unit to confirm that
the fixing shaft is not lowered after
unlocking.