Konica Minolta 0902, Руководство по обслуживанию

Страница: 267 / 302

Chapter 6 Adjustment
6-15
6.6 Adjustment of Pressing Amount
Adjust the pressing amount (distance of the push plate unit moves to absorb the back plate of the
cassette) when the transporter mechanism (transporter motor, etc.) is replaced.
Work outline
Listed below are the number of people and the rough standard of work hours required for performing the
works described in this section.
Requirements
Shown below are the tools requiring to be prepared in addition to the standard tools before performing the
works in this section.
Adjustment method
1
Insert the interlock release key into the interlock
switch.
2
Start the service tool and display the [Adjustment]
panel in [Unit Test] screen.
Note
If the purpose is just to confirm the press down, it can be done by using the step operation
(sequence of operation from insertion to eject of the cassette) in the service tool. See
"4.4
Confirming by Step Operation (Page 4-8)" for the procedure to operate the step operation.
Personnel
Number
Work Hours
1
No. Tool No. Tool
1 Press down size adjusting jig 2 Standard cassette (14 x 17 inches)
3 Interlock release key
Caution
When operating inside the equipment with interlock released and power ON, be aware against
the electrification and pinching.
Second Front Side
Note
Current value right after the "Adjustment"
panel was displayed is in the "Pressing
Amount".