Kongsberg Simrad MF90, Руководство по установке

Страница: 251 / 426

476671/B
249
13 Close the door on the Motor Control Unit. Use a spanner to secure it.
Related topics
Setting to work, page 186
Turning on the MF90 system for the first time, page 243
Turning on the MF90 system for normal use
To use the MF90 system, you must first turn it on. To turn on the MF90 system use the
Power
button on the Operating Panel. The MF90 program starts automatically when the
Processor Unit is turned on.
Caution
You must never permit the MF90 system to transmit (ping) when the ship is in dry dock.
The transducer may be damaged if it transmits in open air.
Procedure
1 Make sure that you have sufficient water depth below the keel before you lower the
transducer.
2 Turn on the display(s).
If required, refer to the instructions provided by the display manufacturer.
3 On the Operating Panel, press
Power
, and keep it depressed for a few seconds.
The blue indicator light in the button flashes while the Operating Panel
establishes contact with the Processor Unit. When the connection has
been made, the blue indicator light is lit permanently.
Wait while the operating system and MF90 program is loaded and
started. Both the Processor Unit and the Transceiver Unit are turned
on automatically.
4 Observe that the
Transceiver On/Off
dialog box opens automatically.
The dialog box offers progress information. You can monitor the progress as the
Transceiver Unit is turned on. A blue circle on the hull unit symbol means that the
Processor Unit communicates with the hull unit control circuitry.
5 Once the program has started, observe that the display presentation fills the entire
screen.
The program starts up using the same settings as the last time you used it. If these
settings are acceptable, continue operation. If you wish to alter any of the settings, see
the relevant procedures.
Setting to work