Kongsberg Simrad MF90, Руководство по установке

Страница: 178 / 426

176
476671/B
AC mains power cable (3-phase) to the Motor Control Unit
A dedicated power cable is required to connect 3-phase mains supply and ship’s ground to
the hoisting motor on the hull unit. The connections are made to the Motor Control Unit.
The cable must be provided by the installation shipyard.
Terminal block
E301
is located at the bottom of
the Motor Control Unit. The three AC mains
power cables, as well as ground, are connected
from the ship’s circuit breakers to
E301
. The
cable screen on the power cable must be
grounded in the cable gland.
Important
The physical connections to the motor are
made inside the terminal box on the motor.
To avoid serious damage to the hoisting motor,
and to ensure that the motor operates properly,
you must verify that the electrical connections
are made in accordance with the supplied
3-phase AC voltage. Observe the difference
between 230 Vac and 380/440 Vac wiring!
Minimum cable requirements
•
Conductors
:4 x 2.5 mm
2
•
Screen
: Overall braided
•
Voltage
: 750 V
•
Maximum outer diame-
ter
: 17 mm(Defined by the cable gland)
Related topics
Cable layout and interconnections, page 143
Cable plans, page 145
Installing the MF90 cables, page 154
Cable drawings and specifications, page 164
Simrad MF90 Installation Manual