Kongsberg Simrad ES80, Руководство по установке, Страница: 239 / 312

416739/A
237
Requirements Results
Motion compensation is operational.
The compensated values are shown.
Date and signature:
Related topics
Test procedures, page 221
Setting to work, page 153
Verifying the communication with a synchronization system
Whenever more than one hydroacoustic system is installed on a vessel, interference may
occur. The ES80 offers functionality for remote transmit synchronization. It can be set up
to operate in either
Master or Slave mode. Synchronization is required in order to avoid
interference if the ES80 is used simultaneously with other hydroacoustic instruments within
the same frequency range. You do not need to do this test if the ES80 shall only operate
in
Standalone mode.
Prerequisites
The ES80 is installed as specified in this manual. To make sure that the the interface is
functional, a relevant synchronization system must be connected to the ES80.
• The ES80 system is turned on and operates normally.
• For "slave" operation, a remote system (for example K-Sync or Simrad TU40 ) must be
available to provide trigger pulses.
• For "master" operation, a remote hydroacoustic system (sonar, echo sounder) is
connected. This remote system must be set up in "slave" mode.
• The vessel is berthed or at sea.
Neither tools nor instruments are required.
Context
Whenever more than one hydroacoustic system is installed on a vessel, interference may
occur. To avoid interference, you have these options:
• The systems are all connected to a common synchronization system.
• One of the acoustic systems is set up as "master", and controls the transmissions on
the other systems.
Setting to work