Kongsberg Simrad ES80, Руководство по установке, Страница: 210 / 312

208
416739/A
12 Provide the accurate physical location of the sensor (or its antenna) with reference to
the vessel’s coordinate system.
The position of certain sensors must be defined as an offset to the Ship Origin in the
coordinate system to maximize performance. These offset values are all required to
allow the ES80 to give you as accurate information as possible. The degree of accuracy
offered by the ES80 is directly related to the accuracy of the information you enter
on the
Sensor Installation
page.
a Select the offset value on the X axis (fore-and-aft direction) from the Ship Origin .
Adjust with a positive value for X if the sensor is located ahead of the ship origin.
b Select the offset value on the Y axis (athwartship) from the Ship Origin . Adjust
with a positive value for Y if the sensor is located on the starboard side of the
ship origin.
c Select the offset value on the Z axis (vertical) from the Ship Origin . Adjust with a
positive value for Z if the sensor is located under the ship origin.
13 Select
Add
to save the new sensor interface you have defined.
The sensor interface is added to the
Installed Sensors
list on the
Sensor Installation
page.
14 Select
Apply
and then
Close
to save all the parameters and close the
Installation
dialog
box.
Related topics
Interfacing peripheral equipment, page 192
Setting to work, page 153
Setting up depth output to an external system
The ES80 can export depth information on a dedicated communication port (serial or
Ethernet) The
Depth Output
page is used to set up the output parameters.
Prerequisites
This procedure assumes that:
• You have a vacant interface port on your Processor Unit.
• You are familiar with NMEA and other relevant datagram formats.
• You know how to set up the parameters for serial and local area network (LAN)
communication.
• The interface port is set up with the correct communication parameters.
• The ES80 system is turned on and operates normally.
Neither tools nor instruments are required.
Simrad ES80 Installation Manual