Kongsberg Simrad ES80, Руководство по установке, Страница: 197 / 312

416739/A
195
a Select the interface port you wish to set up.
b Select
Setup
below the list to open the
Serial Port Setup
or
LAN Port Setup
dialog
box.
c Set up the relevant serial or Ethernet (LAN) communication parameters.
The communication parameters defined for NMEA 0183 are:
•
Baud rate
: 4800 bit/s
•
Data bits
: 8
•
Parity
: Even
•
Stop bits
: 1
Some instruments may provide other parameters and/or options. You must always
check the relevant technical documentation supplied by the manufacturer.
d Select
OK
to save the selected settings and close the dialog box.
6 At the bottom of the page, select
Apply
to save your settings.
7 Repeat for any other communication ports that you need to set up.
8 Close the
Installation
dialog box.
Related topics
Interfacing peripheral equipment, page 192
Setting to work, page 153
Setting up the input from a navigation system (GPS)
For the ES80 to use and offer correct navigational information, one or more external sensors
must be connected. Typical sensors are those providing navigational information (heading,
speed or geographical position). To select which sensors to install, use the
Sensor Installation
page. Your current position is shown on the top bar if you have enabled this in the
Display
Options
dialog box.
Prerequisites
This procedure assumes that:
• You have a vacant interface port on your Processor Unit.
• You are familiar with NMEA and other relevant datagram formats.
• You know how to set up the parameters for serial and local area network (LAN)
communication.
• The interface port is set up with the correct communication parameters.
Setting to work