Kongsberg Simrad ES80, Руководство по установке, Страница: 173 / 312

416739/A
171
4 On the list of connections, select
Internet Protocol 4 (TCP/IPv4)
, and then
Properties
.
5 Select
Use the following IP address
, and type the IP address and network mask.
•
IP Address
: 157.237.15.12
Any address can be used, but 157.237.15.12 is recommended for legacy reasons.
This is particularly important if your system contains old GPT transceivers.
•
Subnet mask
: 255.255.255.0
You can leave
Subnet mask
blank and select
OK
. When you see an error message
saying that the message subnet mask is missing, select
OK
again. A default subnet
mask is then automatically generated.
6 Select
OK
to save the selected settings, and then close all the dialog boxes.
7 Start the ES80 program.
8 Open the
Transceiver Installation
page.
a Open the
Setup
menu.
b On the
Setup
menu, select
Installation
.
c On the left side of the
Installation
dialog box, select
Transceiver
.
9 Under
Transceiver Browsing
insert the IP Address that you just specified for the
Ethernet adapter.
10 At the bottom of the page, select
Apply
to save your settings.
11 Turn each transceiver off and on.
This forces the ES80 to assign new IP addresses within the selected IP range.
Related topics
Turning on the ES80 for the first time, page 164
Setting to work, page 153
Installing one or more transducers
The transducers you wish to use with the ES80 must be "installed" as a part of the software
configuration. Which transducers to use depends on the number of transceivers in your
system, and the licenses you have for these. Unless you replace a broken transducer, or
add a new, you only need to do this once.
Prerequisites
It is assumed that the ES80 software has been installed, and that all relevant license strings
have been applied. You need to know the type and serial number of each transducer that
you wish to install.
Setting to work