Kongsberg Flexview, Руководство по установке

Страница: 21 / 126

922-20207011/1.0
19
– At least 2 meters (6.6 feet) from the path of radar beams. A typical radar beam spreads
20 degrees above and below the plane containing the radiating element.
• Protect the Flexview with a suitably rated fuse or circuit breaker. The power supply
should be adequately filtered to minimize equipment exposure to high-voltage transients
that may occur during engine start or when other high-power equipment is used on board
of the vessel.
• Ground the equipment in accordance to applicable electrical marine/vessel codes.
Note
Where the implementation of these recommendations is not possible, maintain the maximum
practical separation between system components and any other electrical/radio equipment
operation on the vessel.
Support information
If you need technical support for your Flexview you must contact your local dealer, or
our support department.
If you require maintenance or repair, contact your local dealer. You can contact us by phone
at +1 604 464 8144, or by email at:
km.support.vancouver@km.kongsberg.com . If you need
information about our other products, visit http://www.km.kongsberg.com/mesotech . On
our website you will also find a list of our dealers and distributors.
Flexview