Kongsberg EM 2040 MKII, Руководство по установке

Страница: 87 / 248

472405/A
87
Read this first
Detailed information about cable specifications, termination and connectors is provided.
Unless otherwise specified, all cables are supplied by Kongsberg Maritime as a part
of the delivery.
Detailed information about relevant cable specifications, termination and connectors is
provided. Each drawing provides additional information, and may, when applicable,
include minimum specifications, connector terminations and the required number of
cores. Drawings are generally not provided for standard commercial cables. Cables
fall into three categories.
1
System cables
: System cables are provided by Kongsberg Maritime as a part of
the delivery.
2
Shipyard cables
: Shipyard cables must be provided by the shipyard doing the
installation, or the shipowner. The cables must meet the minimum specifications
provided in this publication.
3
Commercial cables
: Commercial cables may be provided by Kongsberg Maritime as
a part of the delivery. The cables may also be included with third party items that
are used with the EM 2040 MKII system.
All electronic installations and corresponding wiring must be in accordance with the
vessel's national registry and corresponding maritime authority and/or classification
society.
Note
It is very important that all cables are properly installed and correctly terminated.
Observe the relevant regulations and work standards. Always leave enough cable slack
close to system units and cabinets to allow for maintenance.
Only skilled and authorized personnel can install the EM 2040 MKII cables.
Kongsberg Maritime accepts no responsibility for damage to the system, or reduced
operational performance, when this is caused by improper wiring.
Before you install or maintain the system cables, make sure that the AC mains circuit
breaker for the system is disconnected.
Cable layout and interconnections