Kongsberg cNODE Micro, Инструкция по эксплуатации

Страница: 25 / 56

426351/A
23
cNODE Micro operation in APOS
cNODE Micro only operates in Cymbal mode and uses the channels M01 - M56 for
SSBL and M57 - M62 for LBL LIC. Channels such as B12 etc are not supported.
Using existing versions of APOS
Existing versions of
APOS may not support
the cNODE Micro
fully. When opening
the
New Transponder
menu in APOS you
can see that there is
no information given
regarding the cNODE
Micro transponder using
Cymbal only.
Installing a new cNODE
Micro transponder in the
New Transponder
menu
in APOS:
1 Select HiPAP
cNODE.
2 Enter serial number
and channel number.
3 Ignore the Alt.
Channel (this is for FSK).
Changing transponder channel
Note
The cNODE Micro transponder uses M-channels only. See the transponder label for
channel information.
If you by mistake change the transponder channel from Mxx channel to Bxx channel
in APOS, it will result in that the transponder will not respond to this command and
the transponder keeps it original channel.
APOS will however change the transponder channel for this transponder in the system
and will use the wrong channel. This means that the transponder will not reply to the
interrogation.
Getting started