Kongsberg cNODE Micro, Инструкция по эксплуатации

Страница: 23 / 56

426351/A
21
Procedure
1 Connect the cable between the cNODE Micro and the ROV.
2 Turn on the power supply (24 VDC) to the cNODE Micro.
Disconnecting cNODE Micro from the ROV
It is very important to read the procedures before disconnecting the cNODE Micro
from the ROV.
Prerequisites
Note
Always turn off the power supply (24 VDC) before disconnecting the cNODE Micro
from the ROV.
Procedure
1 Turn off the power supply (24 VDC) to the cNODE Micro.
2 Disconnect the cable between cNODE Micro and the ROV.
Powering up the TTC
Procedure
1 Place the TTC in a suitable location.
2 Open the case by pressing the handle knobs and pulling the handles up.
3 Turn on the main power switch to load the software (this takes approximately 1.5
minutes).
Result
The system is now ready for operation.
Acoustic test
Perform the acoustic test to make sure the transponder is functioning.
Prerequisites
Pre-deployment checks have been done.
Getting started