Kongsberg ACS500, Инструкция по эксплуатации

Страница: 91 / 148

Maintenance
3 Make sure there is a small O-ring in the flexible pipe and connect the adapter fitting
to the test port for the seal being tested.
4
Make sure there is an O-ring in the other end of the flexible pipe and connect a ¼
BSP.
5 Place a washer on the ¼ BSP and connect to the outlet port
F
on the test kit.
Testing the seal
Purpose
This procedure explains how you can use the interseal test kit to verify that the unit to be
tested is properly sealed and watertight.
Related topics
• Druck DPI104 Digital pressure indicator user manual
• Druck PV411A Hand-pump user manual
• Assemble the test kit on page 88
Important
Before you apply pressure, make sure that all connections are correct, and that all
equipment are clean and free from damage.
Do not exceed the maximum test pressure of 11 bar.
Never use tools to fasten the fittings, hand power is enough.
Procedure
1 Assemble the test kit.
→ Assemble the test kit on page 88
2
Make sure the unit to be tested, and the connections are clean. Verify that the
O-rings on the fittings are lubricated properly.
3 Connect the flexible pipe between the interseal test kit and the unit to be tested.
4
Start the Digital pressure indicator by pressing the power on button,
A
.
397128/C
89