Connecting a PA box to the Konftel 300
ENGLISH
Activating and deactivating of internal microphone and internal speakers
The internal microphone and speakers are turned off by default when the PA box is connected.
Press
MENU
and select
SETTINGS
>
PA
.
Select
INTERNAL MIC
or
INTERNAL SPEAKER
.
Press
OK
to switch between ON (shaded square) and OFF.
It is only the internal microphone that will be turned off. When using external microphones,
they will still be active.
Adjusting PA monitor level
PA monitor can be used to adjust the microphone level from an external microphone mixer.
Make a call.
Press
MENU
and select
PA
>
MONITOR
.
Adjust the microphone level from the mixer so that this value is around 10–12 when speak-
ing in a normal tone of voice.
Adjusting PA calibration
If needed it is possible to calibrate the full duplex performance. The calibration value can be set
to AUTO or be adjusted manually in steps from 0 to 5 where 0 is the highest grade of duplex.
• If the remote party experiences disturbing echoes > increase the calibration value.
• If the remote party experiences a low grade of duplex (your voices is muted when the other
party also is talking) > decrease the calibration value.
The physical position of speakers and microphones as well as amplifier settings may impair
the full duplex performance.
Make a call.
Press
MENU
and select
PA
>
CALIBRATION
.
AUTO is the default setting and is recommended for most situations. The value shown within
brackets is the measured calibration value.
Select different levels and compare the audio quality to retrieve a suitable setting.
SETTINGS
www.konftel.com
Head office in Sweden: Konftel AB, Box 268, SE -901 06 Umeå, Sweden
Phone: +46 90 70 64 89, Fax: +46 90 13 14 35, E-mail: [email protected]
110000-61-001 rev 2a
