Instruction manual SMV 10 600B – 60 1500B Publ. no. 6196.082 1117, Version 02
65
Service and maintenance
• Unscrew the nut (1) and remove the cover.
• Lift up the rotor and loosen the nut on the cover three turns.
NOTE
• If the nut is stuck, fixate it (1),
but not the cover
, in a vice and
turn the cover three turns by hand or using a screw driver.
• Knock on the nut with your hand or a plastic hammer to
remove the cover from the base plate.
• Loosen the nut and remove the cover (2).
• Carefully prise the filter from the base plate.
• Remove any deposits from inside the cover. If there are no
deposits, the cleaning is not working.
• If the deposits are thicker than 20 mm, clean more often.
• Clean all parts in diesel oil.
• Return the o-ring (3) inside the cover. It must not be damaged.
Replace if necessary.
Filling up engine oil
• Remove the filling lid (2).
• Fill oil through the refill opening.
• Check the oil level with the oil dipstick (1). Fill to the
maximum level.
• Replace the filling lid (2).
• Close the engine cover.
BE CAREFUL
When test driving after replacing the oil and
filter, pay attention to the oil pressure gauge and
warning indicator on the instrument panel.
Also check that there are no leaks by the drain plug and oil filter.
In order to perform a careful inspection of the oil level, in
particular when the oil filter has been replaced, it is necessary
to switch off the engine again and then recheck the oil level
after about a minute.
