Komatsu WA800-3E0, Руководство по эксплуатации и техническому обслуживанию

Страница: 50 / 336

PRECAUTIONS FOR OPERATION
SAFETY
2-28
TRANSPORTATION 2
The machine can be divided into parts for transportation, so when transportating the machine, please contact your
Komatsu distributor to have the work carried out.
LOADING AND UNLOADING
(1) Blocks
(2) Ramp
(3) Distance between ramps
(4) Angle of ramps: Max. 15°
When loading or unloading the machine, mistaken operation
may bring the hazard of the machine tipping over or falling, so
particular care is necessary. Always do as follows.
q
Perform loading and unloading on firm, level ground only.
Maintain a safe distance from the edge of the road or cliff.
q
Always use ramps of adequate strength. Be sure that the
ramps are wide, long, and thick enough to provide a safe
loading slope. Take suitable steps to prevent the ramps
from moving out of position or coming off.
q
Be sure the ramp surface is clean and free of grease, oil,
ice and loose materials. Remove dirt from machine-tracks.
On a rainy day, in particular, be extremely careful since the
ramp surface is slippery.
q
Run the engine at low idling and operate slowly at low speed.
q
Never correct your steering on the ramps. If necessary, drive off the ramps, correct the direction, then enter
the ramps again.
q
When loading or unloading to an embankment or platform, make sure that it has suitable width, strength, and
grade.
q
For machines equipped with a cab, always lock the door after boarding the machine. If this is not done, the
door may suddenly open during transportation.
Refer to “TRANSPORTATION (3-135)“.
SHIPPING
When shipping the machine on a trailer, do as follows.
q
The weight, transportation height, and overall length of the machine differ according to the work equipment, so
be sure to confirm the dimensions.
q
When passing over bridges or structures on private land, check first that the structure is strong enough to sup-
port the weight of the machine. When traveling on public roads, check first with the relevant authorities and fol-
low their instructions.
q
Lock the frame with the frame lock bar to prevent the machine from articulating.
q
Fit chains to the front frame and the rear frame to hold the machine securely in position.
q
For details of the shipping procedure, see “TRANSPORTATION (3-135)“ in the OPERATION section.