Komatsu WA800-3E0, Руководство по эксплуатации и техническому обслуживанию

Страница: 328 / 336

HANDLING MACHINES EQUIPPED WITH VHMS
ATTACHMENTS, OPTIONS
6-18
HANDLING MACHINES EQUIPPED WITH VHMS 6
q
VHMS is a machine management system. When a communications terminal is installed, it is possible to trans-
mit data.
q
A contract is necessary before the VHMS communications terminal can be used. Any customers desiring to
use the VHMS system should consult their Komatsu distributor.
VHMS INSTALLED, COMMUNICATIONS TERMINAL NOT INSTALLED 6
BASIC PRECAUTIONS 6
WARNING
q
Never disassemble, repair, modify, or move the VHMS or cables. This may cause failure or fire on the
VHMS equipment or the machine itself. (Your Komatsu distributor will carry out removal and installa-
tion of VHMS.)
q
Do not allow cables or cords to become caught; do not damage or pull cables or cords by force. Short
circuits or disconnected wires may cause failure or fire on the VHMS equipment or the machine itself.
REMARK
There is absolutely no need to inspect or operate the VHMS, but if any abnormality is found, please contact your
Komatsu distributor.
VHMS AND COMMUNICATIONS TERMINAL INSTALLED 6
q
The VHMS equipment is a wireless device using radio waves, so it is necessary to obtain authorization and
conform to the laws of the country or territory where the machine equipped with VHMS is being used. Always
contact your Komatsu distributor before selling or exporting any machine equipped with VHMS.
q
When selling or exporting the machine or at other times when your Komatsu distributor considers it necessary,
it may be necessary for your Komatsu distributor to remove the VHMS equipment or to carry out action to stop
communications.
q
If you do not obey the above precautions, neither Komatsu nor your Komatsu distributor can take any respon-
sibility for any problem that is caused or for any loss that results.
BASIC PRECAUTIONS 6
WARNING
q
Never disassemble, repair, modify, or move the VHMS, terminal, antenna, or cables. This may cause
failure or fire on the VHMS equipment or the machine itself. (Your Komatsu distributor will carry out
removal and installation of the VHMS and terminal.)
q
Do not allow cables or cords to become caught; do not damage or pull cables or cords by force. Short
circuits or disconnected wires may cause failure or fire on the VHMS equipment or the machine itself.
q
For anyone wearing a pacemaker, make sure that the communications antenna is at least 22 cm from
the pacemaker. The radio waves may have an adverse effect on the operation of the pacemaker.