Komatsu WA800-3E0, Руководство по эксплуатации и техническому обслуживанию

Страница: 226 / 336

GUIDES TO MAINTENANCE
MAINTENANCE
4-2
GUIDES TO MAINTENANCE 4
Do not perform any inspection and maintenance operation that is not found in this manual.
CHECK SERVICE METER:
Check the service meter reading every day to see if the time has come for any necessary maintenance to be per-
formed.
KOMATSU GENUINE REPLACEMENT PARTS:
Use Komatsu genuine parts specified in the Parts Book as replacement parts.
KOMATSU GENUINE OILS:
For lubrication of the machine, use the Komatsu genuine lubricants. Moreover use oil of the specified viscosity
according to the ambient temperature.
ALWAYS USE CLEAN WASHER FLUID:
Use automobile window washer fluid, and be careful not to let any dirt get into it.
ALWAYS USE CLEAN OIL AND GREASE:
Use clean oil and grease. Also, keep the containers of the oil and grease clean. Keep foreign materials away from
oil and grease.
CHECKING FOR FOREIGN MATERIALS IN DRAINED OIL AND ON FILTERS:
After oil is changed or filters are replaced, check the old oil and filters for metal particles and foreign materials. If
large quantity of metal particles or foreign materials are found, always report to the person in charge, and carry out
suitable action.
FUEL STRAINER:
If your machine is equipped with a fuel strainer, do not remove it while fueling.
WELDING INSTRUCTIONS:
q
Turn off the engine starting switch.
q
Do not apply more than 200 V continuously.
q
Connect grounding cable within 1 m of the area to be welded. If grounding cable is connected near instru-
ments, connectors, etc., the instruments may malfunction.
q
If a seal or bearing happens to come between the part being welded and grounding point, change the ground-
ing point to avoid such parts.
q
Do not use the area around the work equipment pins or the hydraulic cylinders as the grounding point.
q
Remove the negative (-) terminal of the battery to stop the flow of electric current.
DO NOT DROP THINGS INSIDE MACHINE:
q
When opening inspection windows or the oil filler port of the tank to carry out inspection, be careful not to drop
nuts, bolts, or tools inside the machine.
If such things are dropped inside the machine, it may cause damage and/or malfunction of the machine, and
will lead to failure. If you drop anything inside the machine, always remove it immediately.
q
Do not put unnecessary things in your pockets. Carry only things which are necessary for inspection.