Komatsu WA70-7, Руководство по эксплуатации и обслуживанию

Страница: 159 / 302

Operation 3.3 Operation
WA70-7 – VENAM02003
3-85
Stockpiling
When stockpiling material, do not set the bucket to the maximum
dump or tilt position but rather to the required levelling angle.
The rear counterweight should not touch the ground.
Working with the forklift attachment
Working with a forklift attachment on a wheel loader is different
both from working with a bucket and working with a forklift.
Therefore, observe the following points as well as the instruc-
tions in chapter 2.2 “General precautions” (2-9).

Do not pick up loads that are so high as to block the opera-
tor's view of the route.

Hold the tines of the forklift attachment horizontally when
picking up a load.

While driving, carry the load as close to the ground as possi-
ble in order to have a good view of the route.

Always drive slowly with loads (speed range 1).

The boom executes a semicircular movement during the lift-
ing process. Raise the boom to the desired unloading height
shortly before reaching the location of unloading. This pre-
vents the load from becoming damaged while lifting.

Keep the forklift attachment horizontal when stacking, if pos-
sible.
(500 mm)
(500 mm)
19.685 in
19.685 in
75_156