Komatsu PW98MR-10, Руководство по эксплуатации и техническому обслуживанию

Страница: 328 / 446

1.
Set the work equipment in the position shown in the figure,
then stop the engine and set the lock lever to LOCK posi-
tion (L).
A: Arm
B: Bucket:
2.
Shift O-ring (1) and measure the amount of play "a".
REMARK
Measurement is easier if you move the bucket to one side
so that all the play can be measured at one place (the right
side in the figure).
Use a clearance gauge for easy and accurate measure-
ment.
3.
Loosen plate mounting bolts (2) (4 pieces) and loosen
plate (3).
The shim is a split type, so the work can be performed
without removing the bolts.
4.
Remove shim (4) corresponding to the amount of play "a".
Shim (4) is a set of 2 pieces. The thickness of each piece
of shim (4) is 0.5 mm.
When play "a" is smaller than 1 shim, do not adjust it by
tightening bolts (2).
5.
Tighten bolts (2) (4 pieces).
If bolts (2) are too stiff to tighten, pull out pin stopper bolt
(5) for easier tightening.
METHOD FOR CHECKING WINDOW WASHER FLUID LEVEL, ADDING FLUID
If air is in the window washer fluid, check the fluid level in window washer tank (1).
1.
Check the fluid level in window washer tank (1).
2.
If the level is low, add window washer fluid for automobile.
Be careful not to let dirt or dust get in when adding fluid.
Mixture ratio of pure washer fluid and water
The proper mixing proportion varies with the ambient temperature. Add washer fluid diluted with water at the
following proportion.
Area, season Mixing proportion Freezing temperature
Normal Washer fluid 1/3: water 2/3 –10 °C (14 °F)
Winter in cold district Washer fluid 1/2: water 1/2 –20 °C (–4 °F)
Winter in extremely cold district Pure washer fluid –30 °C (–22 °F)
RKA49020
MAINTENANCE PROCEDURE MAINTENANCE
4-24
WENAM00061