Komatsu PC80MR-5E0, Руководство по эксплуатации и техническому обслуживанию

Страница: 311 / 412

2.
Pull out dipstick (G).
3.
Wipe off the oil from the dipstick with a cloth.
4.
Fully insert dipstick (G) into the dipstick pipe, then remove
it.
5.
Check the oil level with dipstick (G).
The oil level should be between H and L marks on the dip-
stick.
6.
If the oil level is below L mark on dipstick (G), add oil
through the hole for the dipstick.
7.
If the oil level is higher than H mark on dipstick (G), lower it
to a proper level according to the following procedure.
1) Place a container to catch oil under drain valve (P).
2) Loosen drain valve (P) and drain excessive oil.
3) Check the oil level again.
8.
After checking oil level or adding oil, insert dipstick (G) into
the hole.
9.
Remove cover support lever (2) and fix it to the lever lock
securely.
10. Close dirt cover (1).
EVERY 250 HOURS MAINTENANCE
METHOD FOR LUBRICATING WORK EQUIPMENT
NOTICE
• If any unusual noise is generated from any greasing point, perform greasing regardless of the
greasing interval.
• Perform greasing every 10 hours for the first 50 hours of operation on a new machine.
• After the machine is subjected to digging work in the water, be sure to grease the wet pins.
Prepare a grease pump.
1.
Set the machine to the greasing posture shown on the fig-
ure, lower the work equipment to the ground and stop the
engine.
2.
By using a grease pump, pump in grease through the grease fittings shown by arrows.
RKA68900
RKA68910
MAINTENANCE MAINTENANCE PROCEDURE
4-45
WENAM00241