Komatsu PC80MR-5E0, Руководство по эксплуатации и техническому обслуживанию

Страница: 101 / 412

REMARK
• Even if some icons look the same, their display positions and corresponding function switches may differ in
accordance with the screens to be displayed.
• For the guidance icons and their functions not explained previously, see the pages where the control meth-
ods of respective screens are explained.
FUNCTION SWITCHES
The operation of the function switches in the standard screen
AUTO-DECELERATION FUNCTION
Perform the setting of auto-deceleration function after starting the engine.
When the auto-deceleration function is ON, if the work equipment control lever and travel lever are returned to
NEUTRAL position, the engine speed will drop from the operating speed to idle speed approximately 4 seconds
later, and fuel consumption is reduced.
If either of the work equipment control lever or travel lever is operated with the engine at idle speed, engine
speed will return to the previous operating speed, and you can perform the operation.
1.
When function switch “F1” is pressed, and the auto-decel-
eration function is turned ON, the auto-deceleration pilot
lamp lights up in yellow in the bottom center of machine
monitor, and 2 seconds later, it returns to blue.
2.
When function switch “F1” is pressed again, and the auto-
deceleration function is turned off, the auto-deceleration pi-
lot lamp goes out.
WORKING MODE SELECTION
On “Working Mode” screen, you can set the movement or force
of the work equipment in accordance with the content of the
operation.
The operation becomes more efficient by selecting the working
mode to match the content of the operation.
P mode
For heavy-duty operations
E mode
For operations with emphasis on fuel consumption
L mode
For lifting operations
B mode
For breaker operations (For machines ready for installation of attachments)
OPERATION EXPLANATION OF COMPONENTS
3-33
WENAM00241