Komatsu PC210-10 DEMOLITION BASE SPEC., Руководство по эксплуатации и техническому обслуживанию

Страница: 409 / 458

ATTACHMENTS AND OPTIONS AUTOMATIC GREASE SYSTEM
6–11
REFILLING GREASE
If the yellow lamp (5) on the in-cab display (2) illuminates, the
minimum grease level in the reservoir has been reached. The
grease reservoir must be refilled as soon as possible.
GREASING PROCEDURE
1. Remove the dust cap from the filler coupling (7).
2. Carefully clean the filter coupling (7) and the filler coupling
on the filler hose.
3. Fix the filler hose on the filler coupling (7).
4. Fill the reservoir up to the maximum level indicated on the
reservoir (8).
5. Remove the filler hose and fit the dust cap.
6. Fix the filler hose on the filler coupling of the filler pump so
that filler hose stays clean.
REMARK
Do not fill the reservoir before you have a low level indication
(5) on the in-cab display.
SYSTEM TEST
In order to check the system a single lubrication cycle can be
performed as follows:
Move the starter switch to the ON position (B).
Depress the test button (9) on the pump for 3 to 5 seconds.
The system will run a single test. During this test the green
LED (4) of the selected interval on the in-cab display (2) will
flash (2 sec. on/ 2 sec. off).
In order to provide additional grease to all grease points (i.e.
after cleaning the machine) or to vent the system a continuous
lubrication cycle run can be performed.
Move the starter switch to the ON position (B).
Depress the test button (9) on the pump for more than 6
seconds. The system will perform a continuous lubrication
test. During this run the green LED (4) of the selected
interval on the in-cab display (2) will flash (0.2 sec. on / 0.2
sec. off).
The continuous test cycle ends after the starter switch is
moved to the OFF position (A).