Komatsu PC210-10 DEMOLITION BASE SPEC., Руководство по эксплуатации и техническому обслуживанию

Страница: 327 / 458

MAINTENANCE MAINTENANCE SCHEDULE TABLE
4–17
NOTICE
When inserting the element into the body, if the rubber at
the tip is swollen or the outer element is not pushed in
straight, and cover (3) is installed by force with hook (2),
there is a danger that the hook and air cleaner body may
be damaged, so be careful when installing.
9. Install cover (3) as follows.
1) Mate cover (3) to the element.
2) Hook the tip of hook (2) to the fitting part of the air
cleaner body and lock it in position.
3) Lock hooks (2) diagonally, (top and bottom, right and
left) in the same way as when tightening bolts.
4) Always install cover (3) so that evacuator (4) faces the
ground (A).
5) When cover (3) is installed, check that the clearance
between the air cleaner body and cover (3) is not too
large. If it is too large, repeat the installation.
10. Replace decal (9) on the cover (3) with a new decal.
CLEAN INSIDE OF COOLING SYSTEM
CLEAN INSIDE OF COOLING SYSTEM:PC220_KU-B000-255K00A
k
WARNING
q
Immediately after the engine is stopped, the coolant is at a high temperature and the radiator is under
high internal pressure. If the cap is removed under this condition, there is a hazard of burns. Wait for
the temperature to go down, then turn the cap slowly to release the pressure before removing it.
q
When starting the engine while cleaning the machine, set the lock lever in the lock position to prevent
the machine from moving.
q
For details of starting the engine, see "Checks and adjustment before starting engine (3-141)" and
"STARTING ENGINE (3-163)" in OPERATION section.
q
There is a danger of touching the fan if the undercover is left removed.
Never enter in the rear part of the machine when the engine is running.
Stop the machine on level ground and clean the inside of the cooling system or change the coolant.
Clean the inside of the cooling system or change the coolant according to the table below.