Komatsu PC210-10 DEMOLITION BASE SPEC., Руководство по эксплуатации и техническому обслуживанию

Страница: 138 / 458

EXPLANATION OF COMPONENTS OPERATION
3–68
1. Select screen adjustment (camera) (2) on the monitor set-
ting menu screen, then press switch F6.
2. Use switches F2 to F6 to adjust brightness the screen.
F2: Resets an adjusted value to initial value
F3: Moves the indicator to the left by one notch
F4: Moves the indicator to the right by one notch
F5: Cancels the change and returns to the monitor setting
menu screen.
F6: Accepts the change and then returns to the monitor
setting menu screen.
REMARK
As long as "*" mark is displayed in the upper right corner of the
screen, brightness is automatically restricted by the machine
monitor to protect the liquid crystal. Screen adjustment may not
change the screen brightness as long as "*" mark is displayed.
However, it is not an error.
CLOCK ADJUSTMENT
CLOCK ADJUSTMENT:PC-Q1MC-100K00A
On the clock adjustment menu, it is possible to change the setting of the clock displayed on the standard screen
of the monitor.
1. Select clock adjustment (3) on the monitor setting menu
screen, then press switch F6. The screen switches to the
selection menu for the clock adjustment.
q
The following five items can be changed.
(a): GPS Synchronization
(b): Calendar
(c): Time
(d): 12h/24h Mode
(e): Daylight Saving Time
REMARK
q
Since after a long-term storage of a monitor, (b) Calendar
and (c) Time are reset, you must readjust them.
q
When the GPS Synchronization is set to ON, the above are
automatically readjusted.
2. Implement the following setup procedure by operating
switches F3 to F6 on the selection menu screen for the
clock adjustment.