Komatsu PC210-10 DEMOLITION BASE SPEC., Руководство по эксплуатации и техническому обслуживанию

Страница: 66 / 458

PRECAUTIONS FOR MAINTENANCE SAFETY
2–48
q
When removing the battery cables, turn the starting switch to OFF position and, after checking that the sys-
tem operating lamp goes out, set the battery disconnect switch key to OFF position and pull it out.
When removing the battery cables, remove the ground cable (negative (-) cable) first. When installing,
connect the positive (+) cable first, then connect the ground.
q
Tighten the battery cable terminals securely.
q
Secure the battery firmly in the specified position.
WHEN USING HAMMER
WHEN USING HAMMER:ALL-0000-2AKK00A
When using a hammer, pins may fly out or metal particles may
be scattered. This may lead to serious personal injury or death.
Always observe the following.
q
When hitting pins or bucket teeth, there is a hazard that bro-
ken pieces might be sent flying and injure people in the sur-
rounding area. Always check that there is no one in the
surrounding area.
q
If hard metal parts such as pins, bucket teeth, cutting
edges, or bearings are hit with a hammer, there is a hazard
that pieces might be scattered and cause serious personal
injury or death. Always wear protective eye glasses and
gloves.
q
If the pin is hit with strong force, there is a hazard that it may
fly out and injure people in the surrounding area. Do not
allow anyone to enter the surrounding area.
HIGH-TEMPERATURE COOLANT
HIGH-TEMPERATURE COOLANTALL-B210-012K00A
To prevent burns from boiling water or steam spurting out when
checking or draining the coolant, wait for the coolant to cool
down to a temperature where the radiator cap can be touched
by hand. Then loosen the cap slowly to release the pressure
inside the radiator, and remove the cap.
HIGH-TEMPERATURE PARTS
HIGH-TEMPERATURE PARTS:PC220-0000-2AHK00A
To prevent burns from touching high-temperature parts, when checking or carrying out maintenance after stop-
ping engine, check the parts have been cooled down to touch with bare hand before checking or maintenance.
HIGH-TEMPERATURE OIL
HIGH-TEMPERATURE OIL:ALL-0000-2ALK00A
To prevent burns from hot oil spurting out or from touching
high-temperature parts when checking or draining the oil, wait
for the oil to cool down to a temperature where the cap or plug
can be touched by hand. Then loosen the cap or plug slowly to
release the internal pressure and remove the cap or plug.