Komatsu PC210-10 DEMOLITION BASE SPEC., Руководство по эксплуатации и техническому обслуживанию, Страница: 47 / 458

SAFETY SAFETY MACHINE OPERATION
2–29
q
Before starting the engine, check that lock lever (1) is in
LOCK position (L).
q
Adjust the mirrors so that the rear of the machine can be
seen clearly from the operator's seat.
When adjusting, see "Mirrors adjustment (3-154)".
q
Adjust the angle of each camera so that the surrounding
area can be seen clearly from the operator's seat.
When adjusting, see "ADJUST REAR VIEW CAMERA
ANGLE (3-157)".
q
Adjust the armrest to a position for easier operation, and
then fix it securely. Operation in an improper position can
cause a serious personal injury.
When adjusting, see "SEAT ADJUSTMENT (3-153)".
q
Check that there are no persons or obstacles above, below,
or in the area around the machine.
WHEN STARTING ENGINE
WHEN STARTING ENGINE:ALL-0000-181K00A
The machine may suddenly move off and this may lead to serious personal injury or death. Always observe the
following.
q
Start the engine only while sitting in the operator's seat.
q
When starting the engine, sound the horn as a warning.
q
Do not allow anyone apart from the operator to ride on the machine.
q
Do not attempt to start the engine by short-circuiting the engine starting circuit. This may cause fire, serious
personal injury or death.
IN COLD AREAS
IN COLD AREAS:ALL-0000-182K00A
q
If the warm-up operation is not carried out thoroughly, and the work equipment is operated, the reaction of the
work equipment to the operation of the control levers and pedals will be slow and the movement of it may not
be what the operator intended. Be sure to carry out the warm-up operation. Particularly in cold weather, be
sure to carry out the warm-up operation thoroughly.
q
If the battery electrolyte is frozen, do not charge the battery or start the engine with a different power source.
There is a hazard that this will ignite the battery and cause the battery to explode.
Before charging or starting the engine with a different power source, melt the battery electrolyte and check that
there is no leakage of electrolyte before starting.