Komatsu PC210-10 DEMOLITION BASE SPEC., Руководство по эксплуатации и техническому обслуживанию

Страница: 39 / 458

SAFETY GENERAL PRECAUTIONS COMMON TO OPERATION AND MAINTENANCE
2–21
WHEN STANDING UP FROM OPERATOR’S SEAT
When standing up from operator’s seat:PC-0000-17GK00A
Before standing up from the operator's seat, such as when
opening or closing the front window or ceiling window, when
removing or installing the bottom window, or adjusting the posi-
tion of the seat, always lower the work equipment completely to
the ground, set lock lever (1) to lock position (L), and stop the
engine.
If the control levers are touched by mistake, the machine may
suddenly move and cause serious personal injury or death.
WHEN LEAVING MACHINE
WHEN LEAVING MACHINE:PC-0000-17HK00A
If the proper procedures are not taken when parking the
machine, the machine may suddenly move off by itself, and this
may lead to serious personal injury or death. For this reason,
always observe the following.
q
When leaving the machine, always lower the work equip-
ment completely to the ground, set lock lever (1) to lock
position (L), and stop the engine. In addition, lock all parts,
always take the key with you and leave it in the specified
place.
EMERGENCY EXIT FROM OPERATOR’S CAB
Emergency exit from operator’s cab:PC-0000-17JK00A
q
If it should be impossible to open the door of the cab, break the window glass with the hammer supplied and
use the window as an emergency escape.
For details, see "Emergency escape hammer (3-93)"in this volume.
q
When escaping, remove all the pieces of glass from the window frame first and be careful not to cut yourself
on the glass. Be careful also not to slip on the broken pieces of glass on the ground.
ELECTROMAGNETIC INTERFERENCE
Emergency exit from operator’s cab:PC-0000-17JK00A
When this machine is operating close to a source of high electromagnetic interference, such as a radar station,
some abnormal phenomena may be observed.
q
The display on the monitor panel may behave erratically.
q
The warning buzzer may sound.
These effects do not signify a malfunction and the machine will return to normal as soon as the source of interfer-
ence is removed.