Komatsu PC210-10 DEMOLITION BASE SPEC., Руководство по эксплуатации и техническому обслуживанию, Страница: 376 / 458

MAINTENANCE SCHEDULE TABLE MAINTENANCE
4–66
CLEAN HYDRAULIC TANK STRAINER
CLEAN HYDRAULIC TANK STRAINER:PC-PM3E-255K00A
k
WARNING
q
The parts and oil are at high temperature immediately after the engine is stopped, and may cause
burns. Wait for the temperature to go down before starting the work.
q
When removing the oil filler cap, the oil may spurt out. Turn it slowly to release the internal pressure,
then remove it.
1. Remove the cap for oil filler (F), and release the internal
pressure.
2. Remove six bolts, then remove cover (1). When doing this,
cover (1) may jump out under the force of spring (2), so
press the cover down while removing the bolts.
3. Hold the top of rod (3) and pull it up to remove spring (2)
and strainer (4).
4. Remove all the dirt stuck to strainer (4), then wash it in
flushing oil. If strainer (4) is damaged, replace it with a new
part.
5. To install, insert strainer (4) into protruding part (5) of the
tank.
6. Install cover (1) so that the protruding part at the bottom of
cover (1) holds spring (2), then fasten the cover with the
bolts.