Komatsu PC210-10 DEMOLITION BASE SPEC., Руководство по эксплуатации и техническому обслуживанию

Страница: 375 / 458

MAINTENANCE MAINTENANCE SCHEDULE TABLE
4–65
EVERY 2000 HOURS MAINTENANCE
EVERY 2000 HOURS MAINTENANCE:ALL-33E0-015A00A
Carry out the periodic maintenance work of every 100, 250, 500 and 1000 hours of operation at the same time.
CHANGE OIL IN FINAL DRIVE CASE
CHANGE OIL IN FINAL DRIVE CASE:PC220-DF30-292K00A
k
WARNING
q
Immediately after the engine is stopped, the parts or oil are at high temperature and may cause burns. Wait for
the temperature to go down before starting the work.
q
If there is remaining pressure inside the case, the oil or plug may jump out. Loosen the plug slowly to release
the pressure.
q
Do not stand in front of the plug when you loosen the plug.
q
Refill capacity for both right and left: 5.0 litres.
q
Prepare a sliding T-handle (with 1/2” square drive).
1. Set the TOP mark at the top, with the line running on the
TOP mark and plug (P) perpendicular to the ground sur-
face.
2. Place a container under plug (P) to catch the oil.
3. Remove plugs (P) and (F) with the handle and drain the oil.
REMARK
Check the O-rings attached to the plugs for damage. If neces-
sary, replace them with new ones.
4. Tighten plug (P).
5. Add oil through the hole for plug (F).
6. When oil begins to overflow from the hole for plug (F),
install plug (F).Tightening torque of plugs (P) and (F): 68.6 ±
9.8 Nm (7 ± 1 kgm)
REMARK
There are two plugs (F). Add oil through the one of plugs (F)
with which it is easier to add oil and through which no internal
gears are seen.
-5