Komatsu PC210-10 DEMOLITION BASE SPEC., Руководство по эксплуатации и техническому обслуживанию, Страница: 357 / 458

MAINTENANCE MAINTENANCE SCHEDULE TABLE
4–47
CHANGE OIL IN ENGINE OIL PAN, REPLACE ENGINE OIL FILTER CARTRIDGE
CHANGE OIL IN ENGINE OIL PAN, REPLACE ENGINE OIL FILTER CARTRIDGE:PC-AB02-923K00A
k
WARNING
Parts and oil are at high temperature immediately after the engine is stopped and may cause burns.Wait
for the temperature to go down before starting the work.
q
Refill capacity of oil pan: 23.1 litres
q
Prepare a filter wrench
1. Remove the undercover directly under the engine at the
bottom of the machine, then set a container in position to
catch the drained oil.
2. To prevent getting oil on yourself, lower the lever of drain
valve (P) slowly, drain the oil, then raise the lever to close
the valve.
3. Open the cover at the rear right, then use a filter wrench to
turn filter cartridge (1) to the left to remove it.
4. Clean filter holder (2), fill the new filter cartridge with clean
engine oil, coat the thread and packing surface of the new
filter cartridge with clean engine oil (or coat it lightly with
grease), then install it to the filter holder.
REMARK
Check that there is no old packing stuck to filter holder (2). If
there is any old packing stuck to the filter, it will cause leakage
of oil.
5. When installing, tighten until the packing surface contacts
the seal surface of filter holder (2), then tighten it a further 3/
4 to 1 turn.
6. After replacing the filter cartridge, open the engine hood
and add engine oil through oil filler port (F) to the midpoint
between the H and L marks on dipstick (G).
7. Run the engine at idle for a short time, then stop the engine,
and check that the oil level is between the H and L marks
on the dipstick. For details, see "CHECK OIL LEVEL IN
ENGINE OIL PAN, ADD OIL (3-150)".
8. Install the undercover.