Komatsu PC210-10 DEMOLITION BASE SPEC., Руководство по эксплуатации и техническому обслуживанию, Страница: 324 / 458

MAINTENANCE SCHEDULE TABLE MAINTENANCE
4–14
3) Remove one numbered tab from the decal whenever
the element is cleaned.
8. If small holes or thinner parts are found on the element
when it is checked by lightening inside the element it after
cleaning, replace the element.
9. Remove the cloth or tape covering inner element (6).
NOTICE
q
Do not use an element whose folds or gasket or seal
are damaged.
q
If the element and O-ring are cleaned and used again
after they are used for more than one year, it will cause
problems. Do not use them again.
10. Check that there is no dirt or oil stuck to the sealing portion
of the new element or cleaned element. Wipe any dirt or oil
off.
11. Push the outer element straight into the air cleaner body
with your hand when installing.If the outer element is held
and rocked up and down lightly and to the right and left
while pushing it in, the outer element can be inserted easily.
NOTICE
Be sure to install the air cleaner element facing in the cor-
rect direction. Install so that the bottom of the air cleaner
element (face where no hole is drilled) (B), (C) comes to
cover (3) end. If it is installed in wrong direction, it may
cause breakage of the air cleaner element or serious dam-
age to the engine.