Komatsu PC210-10 DEMOLITION BASE SPEC., Руководство по эксплуатации и техническому обслуживанию, Страница: 304 / 458

TROUBLES AND ACTIONS OPERATION
3–234
START ENGINE WITH BOOSTER CABLES
Start Engine with Booster Cables:ALL-AW10-14BK00A
When starting the engine with a booster cable, do as follows.
CONNECT AND DISCONNECT BOOSTER CABLES
CONNECT AND DISCONNECT BOOSTER CABLES:PC220-AW10-14BK00A
k
WARNING
q
When connecting the cables, never contact the positive
(+) and negative (-) terminals.
q
When starting the engine with a booster cable, always
wear protective eyeglasses and rubber gloves.
q
Be careful not to let the normal machine and failed
machine contact each other.
The sparks caused near the battery could ignite the
hydrogen gas generated from the battery, so be careful
not to let it happen.
q
Be careful not to make a mistake when connecting a
booster cable. In the last connection (to the upper
structure frame), a spark will be caused, connect the
cable to a spot as far away from the battery as possible.
(Avoid the work equipment, however, because it is not
a good conductor)
q
When removing the booster cable, exercise good care
so that the booster cable clips may not contact each
other, or they contact the chassis.
NOTICE
q
The starting system for this machine uses 24 V. For the normal machine, also use a 24 V battery.
q
The size of the booster cable and clip should be suitable for the battery size.
q
The battery of the normal machine must have the same capacity as that of the failed machine (engine
to be started).
q
Check the cables and clips for damage or corrosion.
q
Make sure that the cables and clips are firmly connected.
q
Check that the lock levers and parking brake levers (if equipped) of both machine are in the LOCK position.
q
Check that each lever is in the NEUTRAL position.
q
To prevent electric equipment of a failed machine from being damaged, turn off the starting switch of
the failed machine before connecting the booster cables, and then set the battery disconnect switch
key to the OFF position. For the operating method of the battery disconnect switch, see "BATTERY
DISCONNECT SWITCH (3-127)".
REMARK
When the battery disconnect switch is turned off, the radio station select information may be lost. In that case, see
the paragraph of "Handling radio (3-116)"and set again.