Komatsu PC210-10 DEMOLITION BASE SPEC., Руководство по эксплуатации и техническому обслуживанию

Страница: 297 / 458

OPERATION LONG-TERM STORAGE
3–227
LONG-TERM STORAGE
LONG-TERM STORAGEALL-0000-870K00A
BEFORE STORAGE
Before storage:PC220-0000-870K01A
NOTICE
When storing the machine (one month or more), set the
machine in the posture shown in the figure on the right to
protect the cylinder rods.
(To prevent rusting of the cylinder rods)
When putting the machine in storage for a long time (more than one month), do as follows.
q
Clean and wash all parts, then store the machine indoors. If the machine has to be stored outdoors, select
level ground and cover the machine with canvas.
q
Completely fill the fuel tank. This prevents moisture from collecting.
q
Lubricate and change the oil before storage.
q
Coat the exposed portions of the hydraulic cylinder piston rods with grease.
q
Turn OFF the starting switch, turn the battery disconnect switch key to the OFF position and pull it out, then
store the battery after placing a cover on it.
For details of the operating method of the battery disconnect switch, see "BATTERY DISCONNECT SWITCH
(3-127)".
q
Set the attachment control pedal to the lock position on the machines ready for attachments.
q
Set the stop valve to the LOCK position on the machines ready for attachments. Install the blind plugs to the
elbows.
For details of the explanation of LOCK and FREE of the stop valve, see "REMOVAL AND INSTALLATION OF
ATTACHMENT (6-25)".
q
To prevent rust, fill the cooling circuit with Non-Amine Engine Coolant (AF-NAC) to give a density of at least
30% for the engine coolant.
DURING STORAGE
During storage:ALL-0000-870K02A
k
WARNING
If it is necessary to perform the rust-prevention operation while the machine is indoors, open the doors
and windows to improve ventilation and prevent gas poisoning.
q
During storage, operate and move the machine for a short distance once a month so that a new film of oil will
coat moving parts. At the same time, also charge the battery.
q
When operating the work equipment, wipe off all the grease from the hydraulic cylinder rods.
q
If the machine is equipped with an air conditioner, operate the air conditioner for three to five minutes once a
month to lubricate all parts of the air conditioner compressor. Always run the engine at low idle when doing
this. In addition, check the refrigerant level twice a year.