Komatsu PC210-10 DEMOLITION BASE SPEC., Руководство по эксплуатации и техническому обслуживанию, Страница: 281 / 458

OPERATION TRANSPORTATION
3–211
SECURE MACHINE
SECURE MACHINE:PC220-0000-821K00A
NOTICE
q
Stow the radio antenna. Reassemble the mirrors so that they are within the width of the machine.
q
To prevent damage to the bucket cylinder during transportation, put a wooden block under the tip of
the bucket link to prevent the bucket cylinder from touching the floor.
q
The use of rubber matting between the tracks and the trailer bed is highly recommended.
q
Tying down equipment (e.g. chains, shackles etc.) must be in good condition and protected where
crossing or in contact with sharp corners.
q
Check that the engine hood catcher is locked. Hold the handle of the engine hood and raise it slightly.
If it does not open, the catcher is locked.
If the engine hood catcher is not locked, there is a danger that the engine hood may open during trans-
portation.
After loading the machine onto a trailer, secure the machine as follows:
1. Extend the bucket and arm cylinders fully, then lower the
boom slowly.
2. Set the lock lever securely to LOCK position (L).
3. Stop the engine, then remove the key from the starting
switch.
4. Close all of the doors, windows, and covers.
Lock the doors, covers, and caps fitted with locks.
5. Check machine mass on the machine model plate and use
the appropriate rated equipment for tying down the machine
to the trailer.
Select the way of secure the machine according to the transportation form of each territory from the following.