Komatsu PC1250-11, Оригинальное руководство пользователя

Страница: 369 / 452

1.
Open the cover on the rear left side of the machine, and
remove the filter case (1).
2.
Remove the strainer, remove any dirt stuck to the strainer,
then wash it in flushing oil.
If the strainer is damaged, replace it with a new one.
3.
Install the strainer, and install the filter case (1).
METHOD FOR REPLACING PILOT FILTER ELEMENT
k k
WARNING
Immediately after the engine is stopped, its parts and oil are still very hot, and may cause burn injury.
Wait for the temperature to go down, and then start the work.
1.
Open the cover on the rear left side of the machine.
2.
Loosen the drain plug (1) and drain the oil.
Place a container to catch the drained oil under the drain
plug (1).
3.
Loosen the bolt (2) and remove the filter case (3).
4.
Remove the element (4).
5.
Tighten the drain plug (1).
6.
Install the new element, and install the filter case (3).
7.
Tighten the bolt (2).
Tightening torque: 65 to 88 Nm {6.6 to 9.0 kgm}
METHOD FOR REPLACING DRAIN FILTER CARTRIDGE
1.
Turn the filter cartridge (1) counterclockwise by using the
filter wrench, and remove it.
2.
Fill the new filter cartridge with hydraulic oil, apply oil to the
packing surface, then install it.
When installing the cartridge, tighten it until the packing
surface contacts the seal surface of the filter holder, then
tighten it 1/2 to 3/4 of a turn.
EVERY 1000 HOURS MAINTENANCE
Maintenance for every 10, 100, 250 and 500 hours should be performed at the same time.
MAINTENANCE MAINTENANCE PROCEDURE
4-53