Komatsu PC118MR-8, Руководство по эксплуатации и обслуживанию

Страница: 266 / 418

TRANSPORTATION
FUNCTIONING
3-182
LIFTING THE MACHINE 3
WARNING
q
The operator who carries out lifting operations with the crane must be properly qualified.
q
To lift the machine, the cables and the upper lifting bar used must be of an adequate size; do not use
worn out cables or cables with broken strands.
q
Do not lift the machine until the operator has get off and make sure that there are no people in the
surrounding areas before lift it.
q
Do not lift the machine with the turret laterally turned. Before lifting the machine, swing the work
equipment to the sprocket side, then position the undercarriage and the turret parallel to each other.
q
Always keep the machine in horizontal position during the lifting operations.
q
Do not stand under the machine when this is suspended.
q
Do not attempt to lift the machine in any position different from that illustrated below, since it may lose
stability.
NOTICE
q
For details on the weight of the machine, see paragraph "SPECIFICATIONS (5-2)".
q
The lifting procedure is valid only for standard machines.

The lifting method changes depending on the accessories and optional equipment installed on the
machine. In case of machines with different specifications, contact your Komatsu distributor for more
detailed information.
When lifting the machine, carry out the operation on flat ground
as follows.
1. Start the engine, then swing the turret so that the work
equipment is above the sprocket (1) with the undercarriage
and the turret parallel to each other.
2. Completely extend the bucket cylinder and the arm
cylinder, then lower the working equipment to the ground
as indicated in the right diagram, using the cylinder of the
boom.
3. Lower the blade to the ground.
4. Shift the safety lever to the LOCK position (L).
5. Stop the engine, make sure that the space around the cab
is clear, then get off the machine. Close the cab door and
the front window.
WEAM014802