Komatsu HB365LC-3, Руководство по эксплуатации и техническому обслуживанию

Страница: 325 / 506

2.
Install the hook of lock (D) to base bracket (E).
3.
Raise the lever of lock (D).
REMARK
If the reaction force of lock (D) is large, try it again by shift-
ing bracket (C).
4.
Insert connector (A).
Securely insert the connector until it clicks.
PROCEDURES FOR UNLOADING MACHINE
Perform unloading of the machine on a firm, level ground.
Maintain a safe distance from the road shoulder
1.
Apply the brake of the trailer securely.
2.
Set the chocks (1) to the tires to secure the trailer.
3.
Set the right and left ramps (2) parallel to each other and
equally spaced to the right and left of center (3) of the trail-
er. Make the installation angle (4) at maximum of 15°.
If the ramps bend a large amount under the weight of the
machine, put blocks under the ramps to prevent them from
bending.
4.
Remove the chains and wire ropes fastening the machine.
5.
Start the engine.
Warm up the engine fully in cold weather.
OPERATION TRANSPORTATION
3-253