Komatsu HB215LC-3, Руководство по эксплуатации и техническому обслуживанию

Страница: 334 / 492

• Tightening torque of battery terminal fixing nut (A): 9.8 to
11.8 Nm {1.0 to 1.2 kgm}
• When replacing the battery, secure it with the battery
mounting hardware.
Tightening torque of mounting bolt (B):
9.8 to 19.6 Nm {1.0 to 2.0 kgm}
PRECAUTIONS FOR CHARGING BATTERY
k k
WARNING
When charging the battery, if the battery is not handled
correctly, it is dangerous that the battery may explode. Al-
ways follow the instruction manual accompanying the
charger, and observe the following.
• Set the voltage of the charger to match the voltage of
the battery to be charged. If the correct voltage is not
selected, the charger may overheat and cause an ex-
plosion.
• Connect the positive (+) charger clip of the charger to
the positive (+) terminal of the battery, then connect
the negative (-) charger clip of the charger to the nega-
tive (-) terminal of the battery. Be sure to attach the
clips securely.
• Set the charging current to 1/10 of the value of the rat-
ed battery capacity; when performing rapid charging,
set it to less than the rated battery capacity.
If the charger current is too high, the electrolyte will
leak or the battery cells will dry up, and this may cause
the battery to catch fire and explode.
• If the battery electrolyte is frozen, do not charge the
battery or start the engine with a different power
source. It is dangerous that this may ignite the battery
electrolyte and cause the battery to explode.
• Do not use or charge the battery if the battery electro-
lyte level is below LOWER LEVEL line. This may cause
an explosion. Check the battery electrolyte level peri-
odically and add the purified water (such as a commer-
cial battery fluid) to bring the electrolyte level to UP-
PER LEVEL line.
,&
TROUBLES AND ACTIONS OPERATION
3-262