Komatsu HB215LC-3, Руководство по эксплуатации и техническому обслуживанию

Страница: 211 / 492

10. Check and clean all mirrors
Check for damage to all mirrors. If there is damage, repair it. Clean the surfaces of the mirrors and adjust
the angle according to “METHOD FOR ADJUSTING MIRRORS”.
11. Check the seat belt and mounting hardware.
Check the seat belt and mounting hardware for any abnormality. If any damage is found, ask your Komatsu
distributor to replace it with new one.
12. Check the bucket with hook (if equipped) for damage.
Check the hook, guide, and hook mount for damage. If any problem is found, ask your Komatsu distributor
for repair.
13. Check and clean the camera.
Check the camera lens for dirt. If any dirt is found, wipe it off with a dry soft cloth.
Check that the camera mount is not broken nor deformed, and check that the camera is in correct position
or has no abnormality. If any problem is found, ask your Komatsu distributor for repair.
14. Remove dirt from around the aftertreatment devices.
Check for dirt and combustible materials (dry leaves, twigs, etc.) accumulated around the aftertreatment de-
vices. If any dirt or combustible materials are found, remove them.
15. Check around the aftertreatment devices for exhaust gas leakage.
Check the pipe connecting the turbocharger to the aftertreatment devices and also connections of the after-
treatment devices for leakage of exhaust gas (and sticking of urea deposit). If any problem is found, ask
your Komatsu distributor for repair.
16. Check around SCR for exhaust gas leakage.
Check the pipe between the KDPF and SCR and also the SCR connections for leakage of exhaust gas
(and urea deposit). If any problem is found, ask your Komatsu distributor for repair.
17. Visually check the high-voltage wirings.
Visually check the high-voltage wirings for breakage, wear, damage, and loose clamps. If any problem is
found, ask your Komatsu distributor for repair.
18. Check the hybrid component system for water leakage and oil leakage.
Check around the electric swing motor, motor-generator, and lubrication pump for oil leakage, and check
the hybrid component system for water leakage. If any problem is found, ask your Komatsu distributor for
repair.
METHOD FOR CHECKING BEFORE STARTING
Always check the items in this section before starting the engine each day.
HANDLE REFUELLING PUMP
k k
WARNING
• Do not spill the fuel or overflow the fuel when refuelling (it may cause a fire).
• If the fuel is spilled, wipe it off completely. If the fuel is spilled on the soil or sand, remove the soil or
sand.
• Fuel is highly flammable, and it is dangerous. Never bring any open flame close to the fuel.
OPERATION MACHINE OPERATIONS AND CONTROLS
3-139