Komatsu H75051, Руководство по эксплуатации и техническому обслуживанию

Страница: 384 / 440

1.
Apply the parking brake.
2.
Raise the work equipment to the upper end and operate
the multifunction mono-lever to “HOLD” position (b).
3.
Stop the engine.
4.
Turn the starting switch to ON position.
5.
Press the work equipment lock switch and unlock the work
equipment (the pilot lamp goes out).
6.
After checking safety around the machine, operate the
multifunction mono-lever to “FLOAT” position (d) and lower
the work equipment to a position 1 m from the ground.
7.
After the work equipment is lowered to a position 1 m from
the ground, return the multifunction mono-lever to “LOW-
ER” position and lower the work equipment gradually to
the ground.
REMARK
The check must be done within 2 minutes after the engine
stops. If the engine is kept stopped, the gas pressure in
the accumulator lowers and the inspection cannot be
made.
If the work equipment stops halfway, the accumulator gas pressure may be low.
Ask your Komatsu distributor for inspection.
Replace the accumulator for every 4000 hours or every 2 years.
METHOD FOR CHECKING ALTERNATOR
Ask your Komatsu distributor to have the alternator checked.
If the engine is started frequently, have this inspection performed every 1000 hours.
METHOD FOR CHECKING AND ADJUSTING ENGINE VALVE CLEARANCE
Special tools are necessary for inspection and maintenance. Ask your Komatsu distributor to perform this work.
METHOD FOR CHECKING VIBRATION DAMPER
Check that there are no cracks or peeling in the outside surface of the rubber.
If any cracks or peeling are found, contact your Komatsu distributor to have the parts replaced.
METHOD FOR REPLACING KCCV FILTER ELEMENT
k k
WARNING
Immediately after the engine is stopped, the parts are still very hot. Do not replace the filter element im-
mediately. Wait for all parts to cool down before starting the work. Always stop the engine before start-
ing the replacement work.
NOTICE
• Komatsu recommends using Komatsu genuine parts for replacement parts.
• If the engine is operated without the filter element, the turbocharger and aftercooler become dirty
and their performance will lower and it can cause engine problems such as overrun caused by suc-
tion of oil. Never try such practice.
• The filter element cannot be cleaned. Flushing or regenerating of the filter element will degrade per-
formance of the filter. As a result, the turbocharger and aftercooler become dirty and the perform-
ance lowers or the crankcase pressure increases. Never reuse the filter element since it can cause
an engine failure.
• After the filter element is replaced, if KCCV is not assembled correctly, oil or blowby gas may leak.
Replace the filter element in the correct procedure.
MAINTENANCE PROCEDURE MAINTENANCE
4-74